6x6Talk Forum
6x6 Technical Questions => Engine 4 Cycle => Topic started by: Craig_B on August 28, 2018, 04:33:03 PM
-
I have an old Argo TB 8X8 with the Tech. engine.
The oil temperature gauge has just stopped working.
I was hoping someone would know the temp sensors location on the engine so I can follow the wires back to the gauge. Following the wires from the gauge down isnt working.
Thanks
-
I had an old ARGO THD, I think the sender was on the block
Jeff BAr
-
I had an old ARGO THD, I think the sender was on the block
Jeff BAr
Any idea where on the block it was located?
Thanks
-
It should be on the Front or Rear side of the Block. On the Flat surface. About 1 to 2 inches above the drain plug.
-
It should be on the Front or Rear side of the Block. On the Flat surface. About 1 to 2 inches above the drain plug.
Awesome.
Thanks I will have a look this weekend.
-
In case anyone else ever needs the location of the oil temp sensor on a Tech motor it was located below the starter motor on the front side of the engine.
-
Right above the mounting flange and drain plug ? That's where I would say it should be twoCents
-
In the spare drain plug on my Briggs v twin