Author Topic: Broke  (Read 7294 times)

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1640
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: Broke
« Reply #15 on: December 08, 2017, 08:38:25 PM »
Check the center bolt ! Make sure it is Not lose ?
3= Amphicat. 1= StarCraft. 1= Max 2= Attex  And Counting

Offline Delduck

  • Trade Count: (0)
  • Sr. 6x6'er
  • ****
  • Posts: 275
  • Country: us
  • Karma: +0/-0
Re: Broke
« Reply #14 on: December 08, 2017, 08:35:19 PM »
I wish you were closer I would rather PAY YOU   at least I’d be paying someone who has a clue. Not paying someone to learn.  Next potential problem, I have a vibration when the motor is running, it seems to be the clutch that attaches to the t 20 when I pry the clutch open to get the belt on could I have bent that clutch? Or somehow could the red spring have slipped. I just noticed this after the broken axle. At idle motor seems fine, give it a little gas it starts vibrating bad, then more rpms it seems to get better.

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1640
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: Broke
« Reply #13 on: December 08, 2017, 08:27:38 PM »
If it has the strap over it just unbolt it then the Diamond shifter just pulls out. If there is NO pin on the end then there is your problem !
I wish I was closer as I would help you !!
3= Amphicat. 1= StarCraft. 1= Max 2= Attex  And Counting

Offline ascaw

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 743
  • Country: us
  • Karma: +0/-0
Re: Broke
« Reply #12 on: December 08, 2017, 08:26:46 PM »
Ok so I’m going to take the diamond shifter off and see if I can take a screwdriver to manually shift?  I would love to blame the abuse on a previous owner but I’m not easy on equipment. I haven’t looked for it yet but is there a thread, or video, or any how too on this diamond shifter. I hate to take the trans to the shop again, it costs $250 for them to break it open then I have to order the new gaskets from Richard, well you all know the rant :'( enough said thanks for the help. Still 8 ac to go

Try this

http://www.route6x6.com/howto/T-20Shifterremoval/index.html

Put the screw driver in the slot the pin goes in and slide the shift collar in and out.
« Last Edit: December 08, 2017, 08:29:57 PM by ascaw »

Offline Delduck

  • Trade Count: (0)
  • Sr. 6x6'er
  • ****
  • Posts: 275
  • Country: us
  • Karma: +0/-0
Re: Broke
« Reply #11 on: December 08, 2017, 08:23:46 PM »
Ok so I’m going to take the diamond shifter off and see if I can take a screwdriver to manually shift?  I would love to blame the abuse on a previous owner but I’m not easy on equipment. I haven’t looked for it yet but is there a thread, or video, or any how too on this diamond shifter. I hate to take the trans to the shop again, it costs $250 for them to break it open then I have to order the new gaskets from Richard, well you all know the rant :'( enough said thanks for the help. Still 8 ac to go

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1640
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: Broke
« Reply #10 on: December 08, 2017, 08:19:37 PM »
Thank you Thank you very much  O0 8)
3= Amphicat. 1= StarCraft. 1= Max 2= Attex  And Counting

Offline WFO

  • Trade Count: (1)
  • Master 6x6'er
  • *****
  • Posts: 610
  • Country: us
  • Karma: +0/-0
Re: Broke
« Reply #9 on: December 08, 2017, 08:06:55 PM »
HAHAHAHAHAHAHAHAHAHA what a guy rofl
"94" MAX IV SPRINGER & ULTIMATE BEARINGS
BE JUDGED BY YOUR CHARACTER

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1640
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: Broke
« Reply #8 on: December 08, 2017, 07:41:53 PM »
Great Minds think alike  whistling
3= Amphicat. 1= StarCraft. 1= Max 2= Attex  And Counting

Offline Model Citizen

  • Trade Count: (0)
  • Sr. 6x6'er
  • ****
  • Posts: 480
  • Country: 00
  • Karma: +0/-0
Re: Broke
« Reply #7 on: December 08, 2017, 07:35:05 PM »
I like what you both have to say. It's like an echo.

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1640
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: Broke
« Reply #6 on: December 08, 2017, 07:26:12 PM »
OH ? I thought I did with you ? Must have hit the wrong Quote button ?  fls
Oh well I always did like what I had to say !  whistling
3= Amphicat. 1= StarCraft. 1= Max 2= Attex  And Counting

Offline ascaw

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 743
  • Country: us
  • Karma: +0/-0
Re: Broke
« Reply #5 on: December 08, 2017, 07:02:23 PM »
You May have broken the Pin ? Man You are Having a Time with that machine ! :(
Was it used Hard Before you got it ??
Sure Sounds like it !!!
iagree

Wedge, do you realize you just agreed with yourself? ???

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1640
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: Broke
« Reply #4 on: December 08, 2017, 05:59:17 PM »
You May have broken the Pin ? Man You are Having a Time with that machine ! :(
Was it used Hard Before you got it ??
Sure Sounds like it !!!
iagree
3= Amphicat. 1= StarCraft. 1= Max 2= Attex  And Counting

Offline ascaw

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 743
  • Country: us
  • Karma: +0/-0
Re: Broke
« Reply #3 on: December 08, 2017, 05:49:34 PM »
Pull the diamond shifter and check the pin for wear or if it's broke.  While you have it out, shift that side with a straight slot screw driver (forward and reverse) and see if it is working.

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1640
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: Broke
« Reply #2 on: December 08, 2017, 05:47:15 PM »
You May have broken the Pin ? Man You are Having a Time with that machine ! :(
Was it used Hard Before you got it ??
Sure Sounds like it !!!
3= Amphicat. 1= StarCraft. 1= Max 2= Attex  And Counting

Offline Delduck

  • Trade Count: (0)
  • Sr. 6x6'er
  • ****
  • Posts: 275
  • Country: us
  • Karma: +0/-0
Broke
« Reply #1 on: December 08, 2017, 05:22:58 PM »
Broke axle on the left now right side t20 trans has no forward or reverse. Don’t feel any engagement when I move the diamond shifter with my hand forward or backwards. Makes no sense to me that side moved fine when I broke the axle on the other side. :'(