Author Topic: T-20 bushings  (Read 1370 times)

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1272
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: T-20 bushings
« Reply #5 on: September 03, 2017, 10:44:04 AM »
I take it that the flat bar T20 is the one without the Fiber washers ?
Interesting as the StarCraft has that T20 in it.
3, Amphicat. 1, StarCraft. 1, Max 2 And Counting

Offline Phelpsy69er

  • Trade Count: (0)
  • Full 6x6'er
  • ***
  • Posts: 145
  • Country: 00
  • Karma: +0/-0
Re: T-20 bushings
« Reply #4 on: August 29, 2017, 09:21:42 PM »
Oh Thank you guys!! The bushings in the case look great it's the ones that the gear selector goes ino the drum. The bushings that go into the center plate actually look really good too!! I will call Richard and see what he has available for bushings because I really only want to do this one time!!!
Thank you Whipper for the video also. My machinist at work will find it interesting and want to do this!! LOL
phelpsy69er

Offline whipperag

  • Trade Count: (1)
  • Sr. 6x6'er
  • ****
  • Posts: 326
  • Karma: +0/-0
Re: T-20 bushings
« Reply #3 on: August 29, 2017, 09:12:15 PM »
I agree, check with Richard, he's your best bet for any 6x6 parts.
If you have access to a lathe and mill you can just make your own.
Here's a video on the right way to put those bushings in.
The best way is to shrink them in not press them in.

« Last Edit: August 29, 2017, 09:13:55 PM by whipperag »
Whipperag

Offline wedge

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 1272
  • Country: us
  • Karma: +0/-0
  • Run it like a Big Block !
Re: T-20 bushings
« Reply #2 on: August 29, 2017, 05:38:32 PM »
You could check with Richard on his parts site as he sell's T20 parts and kits also.
3, Amphicat. 1, StarCraft. 1, Max 2 And Counting

Offline Phelpsy69er

  • Trade Count: (0)
  • Full 6x6'er
  • ***
  • Posts: 145
  • Country: 00
  • Karma: +0/-0
T-20 bushings
« Reply #1 on: August 29, 2017, 03:15:47 PM »
Has anyone bought thses commercially like from MSC or grainger? I would kind of like to swap these out while I'm this deep into this trans as the bushings do show some wear. So basically has anyone done this or do I need to contact someone for exact replacement parts? Max 6x6 only has ! size as he said the others have to be machined in I guess. I have access to mills and lathes and surface grinder so if I can get bushings close to the right size I'm not too worried about the maching to make them fit.
As always thanks in advance for any and all input!!
Dave
phelpsy69er