« previous next »
Pages: [1]   Go Down

Author Topic: Springer for Max II  (Read 1422 times)

Offline WFO

  • Trade Count: (1)
  • Master 6x6'er
  • *****
  • Posts: 611
  • Country: us
  • Karma: +0/-0
Re: Springer for Max II
« Reply #5 on: September 21, 2019, 12:00:52 PM »
 popcorn
Logged
"94" MAX IV SPRINGER & ULTIMATE BEARINGS
BE JUDGED BY YOUR CHARACTER

Offline Geneo

  • Trade Count: (0)
  • 6x6'er
  • **
  • Posts: 15
  • Country: us
  • Karma: +0/-0
  • Max II with my mods
Re: Springer for Max II
« Reply #4 on: June 09, 2019, 06:11:08 PM »
My plans are using an Arctic Cat 4x4 400 rear suspension.  This is the mock up and a templet for the left side. Next is one for the right side.
« Last Edit: August 09, 2019, 09:30:06 PM by Geneo »
Logged

Offline WFO

  • Trade Count: (1)
  • Master 6x6'er
  • *****
  • Posts: 611
  • Country: us
  • Karma: +0/-0
Re: Springer for Max II
« Reply #3 on: June 08, 2019, 02:55:18 PM »
have you decided what axles and joints you will use.
Logged
"94" MAX IV SPRINGER & ULTIMATE BEARINGS
BE JUDGED BY YOUR CHARACTER

Offline WFO

  • Trade Count: (1)
  • Master 6x6'er
  • *****
  • Posts: 611
  • Country: us
  • Karma: +0/-0
Re: Springer for Max II
« Reply #2 on: June 07, 2019, 11:35:05 PM »
you would have to a few atv's to take them from. they would all have to be the same. since your only building one it might be feasible .
Logged
"94" MAX IV SPRINGER & ULTIMATE BEARINGS
BE JUDGED BY YOUR CHARACTER

Offline Geneo

  • Trade Count: (0)
  • 6x6'er
  • **
  • Posts: 15
  • Country: us
  • Karma: +0/-0
  • Max II with my mods
Springer for Max II
« Reply #1 on: June 07, 2019, 11:26:34 PM »
What do you all think about using the suspension from an ATV on a Max II ?
Logged
Pages: [1]   Go Up
« previous next »