« previous next »
Pages: [1]   Go Down

Author Topic: plastic molding ?  (Read 1625 times)

Offline ascaw

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 744
  • Country: us
  • Karma: +0/-0
Re: plastic molding ?
« Reply #4 on: July 30, 2022, 05:39:22 PM »
See if you can find a stamping or marking info on the plastic you are wanting to modify.
Logged

Offline garretttpe

  • Trade Count: (0)
  • Sr. 6x6'er
  • ****
  • Posts: 449
  • Country: us
  • Karma: +0/-0
Re: plastic molding ?
« Reply #3 on: July 30, 2022, 05:11:55 PM »
thanks
No clue on the type of plastic SXS's use. plenty of room between tire and inner fender for a couple extra inches.
Logged

Offline ascaw

  • Trade Count: (2)
  • Master 6x6'er
  • *****
  • Posts: 744
  • Country: us
  • Karma: +0/-0
Re: plastic molding ?
« Reply #2 on: July 30, 2022, 05:04:24 PM »
What type of plastic is it?  The Max he molded is HDPE.  If it is a plastic you can mold with heat you need to keep clearances in mind. IE tire, suspension and anything else around there.
Logged

Offline garretttpe

  • Trade Count: (0)
  • Sr. 6x6'er
  • ****
  • Posts: 449
  • Country: us
  • Karma: +0/-0
plastic molding ?
« Reply #1 on: July 30, 2022, 01:11:33 PM »
Hi Guys
got all my stuff moved then hit the road again.. we are looking at Artic Cat wildcat's, the ranger is not cut out for trails. my question is can I do some heat molding to the plastic in the driver side fender area where your left foot would be? I know it works on the MAX. I like the machines but could use another couple inches for my left foot,  I know whipper has done it for his clutch area on his max
thanks for any advice before I buy one.
Larry
Logged
Pages: [1]   Go Up
« previous next »